
In short
- A new noise almost always means a mechanical fault.
- Switch the drive off straight away and run no software.
- The data is recovered in a cleanroom after the heads are replaced.
The reflex to have straight away
Shut the computer down or unplug the drive. Do not plug it back in "to see", and do not run CHKDSK or recovery software. A noisy drive does not fix itself, and each power-up can turn a recoverable fault into permanent loss.
What each noise means
| Noise | Likely fault | Severity |
|---|---|---|
| Regular clicking | Read heads or firmware | High |
| Beeping or buzzing, no spin | Heads stuck to the platters or seized motor | High |
| Grinding or scraping | Heads touching the surface | Critical |
| Spins up and stops, in a loop | Power, heads or firmware | Medium to high |
Regular clicking
The heads cannot read the positioning information and return to their parking position again and again. Possible causes: heads damaged by a knock, wear, or firmware that cannot load its modules. If the heads touch the surface, the platters are scratched on every turn.
Beeping or buzzing
The motor cannot start: the heads are often stuck to the platters, or the motor itself is seized. It is common on 2.5-inch drives in laptops and external enclosures after a fall.
Grinding
This is the most worrying sound: it usually means contact between the heads and the surface. Switch off immediately.
What not to do
- Do not put it in the freezer: condensation settles on the platters.
- Do not tap or shake it to "free" the heads.
- Do not open it, even to take a look: a speck of dust is larger than the gap between the heads and the platter.
- Do not swap the circuit board with one from another drive: the board holds calibration data specific to your drive.
How a clicking drive is recovered
The drive is opened in an ISO 5 cleanroom. The head stack is replaced with one from a donor drive of the same model and firmware family, then the drive is imaged sector by sector, starting with the most important areas (file system, then your folders). If the platters have light scratches, the copy goes around damaged zones. The files are rebuilt from the image, and you receive the list before paying.
See hard drive data recovery and External hard drive not detected.
Frequently asked questions
Can a clicking hard drive be recovered?
In most cases, yes, provided it is switched off quickly. The longer it clicks, the higher the risk of scratched platters.
How much does it cost?
A mechanical fault in the cleanroom costs from €700 to €1,000. Diagnosis is free and if nothing is recovered you pay nothing.
Is your data important?
Do not try anything that could make the fault worse. The diagnosis is free and you get a fixed quote before any work starts.



