
In short
- Check cable, port and power first.
- Never accept 'Initialise disk' or 'Format'.
- On many recent models the original board is essential because the data is encrypted.
Safe checks, in order
- Try another USB cable, preferably a short one, and another port directly on the computer (not a hub).
- For a 3.5-inch drive with a power adapter, check the adapter light and listen: does the drive spin?
- Try another computer.
- On Windows, open Disk Management (right-click the Start button). On a Mac, open Disk Utility and choose "Show all devices".
If the drive appears with its size but no letter, a letter can be assigned. If it appears as "Unknown, not initialised" or "RAW", stop there.
The prompts you must refuse
- "You need to format the disk before you can use it": Windows cannot read the file system. Formatting writes a new, empty one.
- "Initialise disk": this writes a new partition table over the old one.
- "The disk you inserted was not readable by this computer" on a Mac, with an Initialise button: same thing.
Click Cancel, unplug the drive and leave it alone.
Signs that the drive itself has failed
- Clicking, beeping or a spin that starts and stops: see Hard drive clicking: what the noise means.
- The drive gets very slow, then disappears.
- A burning smell or no sign of life after a power surge.
Encrypted drives and soldered connectors
On many WD My Passport models and some other brands, the USB connector is soldered directly onto the drive's board and the data is encrypted by the bridge chip, even if you never set a password. Taking the drive out of its case and connecting it with a SATA adapter does not work, and replacing the board with another one destroys the encryption key. If the connector is broken, the original board must be repaired.
When to send it to a lab
As soon as the drive makes a noise, appears with a wrong size, or none of the checks above helps. See hard drive data recovery.
Frequently asked questions
My drive appears in Disk Management but asks to be initialised. What now?
Do not initialise it. The partition table or the encryption layer is not being read correctly. Unplug it and contact us.
Can I take the drive out of its enclosure?
Only on models without a soldered connector. On many recent portable drives, removing it gains nothing and can damage the board.
Is your data important?
Do not try anything that could make the fault worse. The diagnosis is free and you get a fixed quote before any work starts.



